Please login or register.

Login with username, password and session length
Advanced search  


Reading the forum on your cell phone? There's an easier way. We've enabled a Tapatalk app that makes browsing the forum a whole lot easier. Check it out in the iPhone or Android store if you don't own it already.

Pages: [1]   Go Down

Author Topic: Anchor on p1 Standard  (Read 397 times)

JJ Jameson

  • NEClimbs Junior Member
  • **
  • Offline Offline
  • Posts: 92
Anchor on p1 Standard
« on: March 12, 2014, 11:07:29 AM »

Was up this past Monday/Tuesday for a quick NH blast, showing a friend some classic NE ice.
Had to get him into the Cave on Standard, even though we didn't have time to go above it.
As we were prepping to rap down, I checked the bolts (as I always do) by hand, and noticed the left side bolt's nut is only finger tight. Was easily able to tighten or loosen it by hand. I didn't have any thing with me to tighten it. So figured I'd pass the info along to the current locals so someone could snug it back up.
Hey David, it was nice meeting and chatting with you.



  • NEClimbs God
  • *****
  • Offline Offline
  • Posts: 4626
Re: Anchor on p1 Standard
« Reply #1 on: March 12, 2014, 11:17:59 AM »

JJ- you should have pulled it  ::)


  • Guest
Re: Anchor on p1 Standard
« Reply #2 on: March 13, 2014, 06:10:10 PM »

You as well JJ... one of these days I'll carry a small wrench with me... I think that nut has been loose for a couple years TBH... hand tight is fine for me on a redundant rap anchor, but someone should give it a little torquing...
Pages: [1]   Go Up

Page created in 0.126 seconds with 22 queries.